Brother MFC-9440CN - General Safety Precautions; Preventing Physical Injuries; Toner Handling Safety; Machine Moving Safety

Confidential
2-18
(24) Remove the nine cup S M3x6 Taptite screws (8 pieces from the top and 1 piece from the
front side), and then remove the Scanner cover.
Fig. 2-26
(25) Disconnect the two flat cables (CN1, CN4) and connector (CN8) from the Laser unit.
Note:
After disconnecting the flat cable(s), check that each cable is not damaged at its end or
short-circuited.
Fig. 2-27
Scanner cover
Taptite, cup S M3x6
Taptite, cup S M3x6
Taptite, cup S M3x6
Taptite, cup S M3x6
Frame unit
<Front>
Laser unit
<Front>