Brother MFC-9440CN - Legal Limitations for Copying; Prohibited Documents for Copying; Copyrighted Works and Fair Use

Confidential
2-26
(16) Connect the two Connectors (CN14, CN21) and Flat cable (CN18) into the Main PCB
ASSY.
Note:
When connecting the Flat cable(s), do not insert it at an angle. After insertion, check that
the cable is not at an angle.
Fig. 2-42
(17) Catch the Hooks of the Side cover R ASSY with the main body in the order of 17a to 17e
and fix the Side cover R ASSY with the two cup B M4x12 Taptite screws and two cup S
M4x8 Taptite screws.
*1
Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the
screw) with your hand until you feel that the screw is a little dropped in the hole. Then,
slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten
it according to the specified torque with a screwdriver.
Fig. 2-43
Taptite, cup S M4x8
Hooks
Side cover R ASSY
Taptite, cup S M4x8
Taptite, cup B M4x12
(Tightening torque: 0.80 ±0.1 N m) *1
Hooks
<Right side>
17a
17b
17c
17d
17e
Hook
Document scanner unit
CN21
CN14
Flat cable (CN18)
Main PCB ASSY
<Left side>