Brother MFC-9440CN - Page 173

Confidential
3-41
(3) Remove the two cup B M4x12 Taptite screws and cup S M3x6 Taptite screw.
(4) Disconnect the Connector.
(5) Remove the Paper eject ASSY DX/SX.
Fig. 3-23
*1
Tightening Note:
When tightening the screw, slowly turn it counterclockwise (in the direction to loosen the
screw) with your hand until you feel that the screw is a little dropped in the hole. Then,
slightly turn it clockwise (in the direction to tighten the screw) with your hand and tighten
it according to the specified torque with a screwdriver.
Parts Replacement Note:
The Paper eject ASSY DX/SX is supplied with the Drive shaft holder already fitted. When
replacing the Paper eject ASSY DX/SX, remove the Drive shaft holder from the supplied
Paper eject ASSY DX/SX first, then assemble the Paper eject ASSY DX/SX.
Fig. 3-24
Taptite, cup S M3x6
Taptite, cup B M4x12
(Tightening torque: 1.20 ±0.1 N m) *1
Taptite, cup B M4x12
(Tightening torque: 1.20 ±0.1 N m) *1
Paper eject ASSY DX/SX
Drive shaft holder
Taptite, bind B M3x10
Paper eject ASSY
DX/SX
<Back side>
Connector