Brother MFC-J6730DW - Page 219

3-96
Confidential
9.45 Carriage Motor
(1) Release the Boss and five Hooks and remove the Tube protector from the CR
frame ASSY.
Fig. 3-113
(2) Release the wiring of the Carriage motor harness.
(3) Remove the three screws (TAPTITE CUP B M3x10) from the CR frame ASSY.
Assembling Note: When tightening the three screws (TAPTITE CUP B M3x10),
tighten them in the order shown in the figure.
(4) Remove the two CR frame springs from the CR frame ASSY.
(5) Release the Hook and remove the CR frame ASSY from the Main body.
Fig. 3-114
Hooks
Hook
Boss
Tube protector
CR frame ASSY
Tube protector
Boss
CR frame ASSY
CR frame spring
CR frame ASSY
Hook
TAPTITE CUP B
TAPTITE CUP B M3x10
M3x10
1
2
3
4
5
Carriage motor harness