Confidential
iv
9.11 Main PCB ASSY..................................................................................................3-65
9.12 MJ PCB ASSY.....................................................................................................3-67
9.13 Power Supply PCB ASSY ................................................................................... 3-68
9.14 Carriage PCB ASSY............................................................................................ 3-71
9.15 Ink refill ASSY......................................................................................................3-73
9.16 Ink Absorber Box / Ink Absorber Felt (For Ink Refill ASSY) ................................ 3-76
9.17 CR Encoder Strip / Encoder Strip Guard Film .....................................................3-77
9.18 PF Encoder Disk / PF Encoder Sensor PCB ASSY ............................................3-79
9.19 Carriage Motor ASSY..........................................................................................3-80
9.20 Flushing Base / Flushing Box.............................................................................. 3-83
9.21 Paper Feed Motor................................................................................................3-84
9.22 Maintenance Unit.................................................................................................3-86
9.23 Paper Feed Roller ............................................................................................... 3-87
9.24 Platen ASSY........................................................................................................3-88
9.25 Paper Ejection Roller ASSY ................................................................................ 3-89
9.26 Registration Sensor PCB ASSY.......................................................................... 3-90
9.27 Ink Cartridge Cover Sensor ASSY ...................................................................... 3-91
9.28 Paper Pull-in Roller.............................................................................................. 3-92
9.29 Base Pad on Paper Tray ASSY...........................................................................3-93
CHAPTER 4 ADJUSTMENTS AND UPDATING OF SETTINGS, REQUIRED AFTER
PARTS REPLACEMENT............................................................................... 4-1
1 IF YOU REPLACE THE MAIN PCB ASSY.................................................................... 4-1
1.1 Customize Destinations (Maintenance mode 74).................................................. 4-2
1.2 Automatically Set the CIS Type (Maintenance mode 59)......................................4-2
1.3 Install the Firmware ............................................................................................... 4-2
1.4 EEPROM Parameter Initialization (Maintenance mode 01) .................................. 4-6
1.5 Set the Serial Number (Maintenance mode 80) .................................................... 4-6
1.6 Update the Head Property Data (Maintenance mode 68) .....................................4-8
1.7 Adjust the Touch Panel (Maintenance mode 78)
(only for models with a touch panel)......................................................................4-8
1.8 Acquire Black and White Level Data (Maintenance mode 55) ..............................4-9
1.9 Adjustment of Software Correction for Inclination/Corrugation/Ruled Lines
(Maintenance mode 65).........................................................................................4-9
1.10 Update the Paper Feeding Correction Values (Maintenance mode 58)................4-9
1.11 Margin Adjustment in Borderless Printing (Maintenance Mode 66) ......................4-9
1.12 Reset Purge and Flushing Counts (Maintenance mode 80)..................................4-9
1.13 Creating of Head Calibration Data and Writing it into Flash ROM
(Maintenance mode 02).........................................................................................4-9
To Next Page
Loading...
Need help?
General