FOREWORD
SYMBOLS
SYMBOLS
Listed in the table below are the symbols indicating instructions and other important information neces-
sary for proper servicing. Please note the definition for each symbol. You will find these symbols used
throughout this manual. Refer back to this table if you are not sure of any symbol(s) meanings.
SYMBOL DEFINITION SYMBOL DEFINITION
Torque control required. Data beside
it indicates specified torque.
Apply NUT LOCK™.
Apply oil. Use engine oil unless
otherwise specified.
Apply ULTRA LOCK™.
Apply HPF XR™ Gearcase
Lubricant.
Measure in DC voltage range.
Apply MOLY LUBE™.
Measure in resistance range.
Apply TRIPLE-GUARD
®
Grease.
Measure in continuity test range.
Apply THREE BOND “1104”.
Use peak voltmeter “Stevens CD-77”.
Apply THREE BOND “1207B”.
Use special tool.
Apply SILICONE SEAL.
To Next Page
Loading...
Need help?
General
