BRP Johnson 4HP - Disassembly

4-6
FUEL SYSTEM
CARBURETORS
DISASSEMBLY
When disassembling the carburetor, refer to the assembly
diagram. Refer to specification to identify carburetor model
identification.
Remove the following parts:
• Carburetor 1
• Screw 2
• Spring 3
• Idle adjusting screw 4
• Pilot jet 5
• Main nozzle 6
• Main jet 7
• Needle valve 8
• Clip 9
• Float pin 0
• Float A
• Float chamber gasket B
• Float chamber C
• Drain screw D
• Screw E
Always remove the float pin from the right side to the left
side. (See the figure.)