Bruker BPHG 90 - Ethernet Connection; USB Connection; Mains Power Connection

Installation
Z33081_00_001 39
6.2.3 EthernetConnection
TheBPHG 90 can optionally beconnected viaan Ethernetlink toan externalcomputer.
ConnecttheEthernetcableontherearpanel(labeledETH)toafreeEthernetportonthe
externalcomputer,usingastandardRJ45Ethernetcable.
6.2.4 USBConnection
The generator has an USB port on rear panel for updating the firmware. This port is
reservedforusebytrainedservicepersonnelonly.
6.2.5 MainsPowerConnection
TheBPHG90isconnectedtothemainsusinga3wiregroundedpowercordratedfor600
W. Plug the power cord into the rear power connector and connect the other end to the
walloutlet.TheBPHG90cannowbeswitchedon.Therearpowerswitchonthesocket
mustbeinONposition.
ThelinesocketcontainstwoT4A/250Vfusesinasmalldrawer.Ifthefusesneedtobe
replaced,alwaysusethesametypeandrating.
TheredpowerswitchonthefrontisusedtoswitchtheinstrumentONandOFF.Aredlight
inthefrontpowerswitchindicatesthatlinevoltageispresent.