15
ZTKS0156 / Z31820 / Rev.: 03
2 Safety
The supplied cryostat of the magnet system was designed and manufactured according
to best available technical knowledge and practice, archived in over 50 years of experi-
ence of Bruker Corporation. International standards for quality and approval recom-
mended for cryostats of superconducting magnets were certified.
Nevertheless non-compliance with the following instructions and safety advice may
cause serious hazards and property damage.
2.1 Approved Persons
Bruker BioSpin AG identifies the following qualifications for personnel performing tasks
on the magnet system or its components:
Approved Customer Personnel:
As a result of professional training by Bruker Service Personnel, experience and
knowledge of applicable regulations these persons are qualified to perform the specific
tasks on the magnet system and its components assigned to them in this manual.
Approved Customer Personnel are qualified to identify possible hazards and risks
associated with the tasks assigned to them and to perform all possible steps to eliminate
or minimize these risks.
Bruker Service Personnel:
These persons are qualified by appropriate qualification and professional training and
experience (including all necessary knowledge of applicable regulations and regulatory
requirements) to perform specific tasks on the magnet system and its components.
Bruker Service Personnel are qualified to identify possible hazards and risks and to
perform all possible steps to eliminate or minimize these risks.
To Next Page