Bruker RS - Page 25

25
ZTKS0156 / Z31820 / Rev.: 03
Safety
Risk of Hot Surfaces
Transportation
WARNING
Risk of injury from contact with hot or cold surfaces.
Surfaces of the Cryogenic Refrigerator parts may be hot. Skin contact with these
surfaces can cause serious injuries.
Thus:
• Any work at the Cryogenic Refrigerator parts must only be performed by Bruker
Service.
• Always wear protective gloves while handling Cryogenic Refrigerator parts.
CAUTION
Risk of injury and property damage due to incorrect transportation.
The box may tilt, movement may get out of control. Thus persons may get injured
and the cryostat or further equipment may be damaged.
Thus:
• Be careful while unloading and moving the boxes.
• Do not move the boxes arbitrarily.
• Pay attention to all symbols on the boxes.
• Pay attention to sharp edges and spikes of boxes and parts by using protective
gloves while moving.
• Move the boxes in an upright position.
• Do not tilt the boxes.
• Prevent crossing thresholds, even if they are only a few millimeters high.
• Clean the transportation way before transporting the box.
• Unpack shortly before assembling.
• The cryostat or further equipment must be protected from rain and other bad
weather conditions during transportation.
• Exclusively move the cryostat in its original box.
• Do not remove the tightening straps inside the box until assembling.
• Only use the attachment points provided.
• Ensure that the cryostat is always leveled during any transportation.
• Transportation only with transportation locks attached.
• Do not move the evacuated cryostat.
• Do not move the cryostat after cool down.