BTL-5000 SERIES
USER'S MANUAL
page 27 of 56
Setting polarity between ultrasound head and electrode
After interconnection with the electrotherapy device, the ultrasound head becomes the anode (+). The other pole is
cathode (-) which is the electrode with black banana plug. If the ultrasound head is required to be the cathode (-)
during combined therapy, select ‘negative polarity’ in the therapy parameters screen of the electrotherapy unit.
To apply electrotherapy only with interconnected units, cancel the choice ‘interconnection with electrotherapy’ on
the BTL-5000 Sono screen. The electrotherapy electrodes are automatically connected to the electrotherapy output.
2.10.3 Interconnection of BTL-5000 Puls, BTL-5000 Sono and
BTL vac
To connect the three units, follow this diagram:
(the pictures serve only as an illustration, for actual interconnection follow the table below and the table Tab. 2.1
Configuration of output connectors)
Electrotherapy BTL-56xx Puls Ultrasound BTL-5710 Sono
Connector Connected accessories Connector Connected accessories
E1
Interface cable for
BTL-5000 Sono
U1A 1 cm
2
ultrasound head
E2* Interface cable for BTL vac (IN2) U1B 4 cm
2
ultrasound head
E3* electrodes E input Interface cable for electrotherapy
* if available E output Interface cable for BTL vac (IN1)
BTL-5000
Puls
BTL-5000
Sono
BTL vac
To Next Page
Loading...
