Burkert 8692 - Page 30

29
Type 8692, 8693
english
Description of System
7.3 Specifications of the Positioner
7.3.1 Operating Conditions
CAUTION!
If used outside, the device may be exposed to direct sunlight and temperature fluctuations which may cause mal-
functions or leaks!
The device must not be used outside. •
Ambient temperature 0 - + 55 °C
Protection type IP 65 in accordance with EN 60529
(only if cables, plugs and sockets have been connected correctly)
7.3.2 Conformity with the following standards
CE conforms to EMC Directive 2004/108/EC (until now: 89/336/EEC)
(only if cables, plugs and sockets have been connected correctly)
7.3.3 Mechanical data
Dimensions see data sheet
Body material exterior: PPS, PC, VA, interior: PA 6; ABS
Sealing material NBR / EPDM
7.3.4 Electrical data
Connections cable entry (24 V DC) or
multi-pole plug (Profibus DP, DeviceNet, 24 V DC)
Power supply 24 V DC ± 10 % max. residual ripple 10 %
Power input < 5 W
Input resistance 180Ω at 4 - 20 mA / 12 bit resolution
for actual value signal 17 kΩ at frequency, 0 – 1000 Hz / 1‰ of measured value
> 300 mV
ss
sine, square, triangle
PT 100 - 20 – + 220 °C, resolution < 0.1 °C
Input resistance 180 Ω at 0/4 - 20 mA / 12 bit resolution
for nominal value signal 19 kΩ at 0 - 5/10 V / 12 bit resolution
Protection class 3 in accordance with VDE 0580
Analogue position feedback
max. current
for voltage output 0 – 5/10 V 10 mA
max. load
for current output 0/4 – 20 mA 560 Ω
Inductive proximity switches
current limitation 100 mA
Binary outputs galvanically isolated
Current limiting 100 mA, output is clocked
Binary input galvanically isolated
0 – 5 V = log "0", 10 – 30 V = log "1"
input inverted accordingly