2.0 06/2012 © CAME Cancelli Automatici S.p.A. - The data and information in this manual may be changed at any time and without obligation on the part of Came Cancelli Automatici S.p.A. to notify said changes.
ENGLISH
Menu map
F 1 Total stop feature (1-2)
F 2 Function associated to CX input
F 3 Function associated to CY input
F 5 Safety test function
F 6 Maintained action function
F 7 Command mode on 2-7
F 8 Command mode on 2-3
F 9 Obstacle detection when motor is idle function
F 10 Indicator light function
F - 11 Excluding encoder
F 14 Sensor-type selection feature
F 16 Recoil function
F 18 Supplementary light feature
F 19 Automatic closing time
F 20 Automatic closing time after partial opening;
F 21 Pre-flashing time
F 22 Working time
F 23 Delay time when closing
F 24 Delay time when closing
F 30 Adjusting motor slow down speed
F 34 Sensitivity during movement
F 35 Sensitivity during deceleration
F 36 Adjusting open-partially
F 37 Adjusting the motor's starting point of slow down when opening
F 38 Adjusting the motor's starting point of slow down when closing
F 39 Adjusting the motor's end-strike starting point when opening
F 40 Adjusting the motor's end-strike starting point when closing
F 46 Setting the number of motors
F 50 Saving date in the memory roll
F 51 Reading memory roll data
F 59 Enabling CAME logo feature
U 1 Registering new users with associated command
U 2 Cancelling one user
U 3 Completely cancel users
A 2 Motor test
A 3 Calibrating travel
A 4 Reset parameters
H 1 Software version
To Next Page
Loading...
Need help?
General
