Camus Hydronics ProtoNode FPC-N34 User Manual

Page 74 of 87
ProtoCessor 1991 Tarob Court Milpitas, California 95035 USA Web: www.protocessor.com
Tel: (408) 964-4444 Fax: (408) 964-4425 email: support@protocessor.com
107
Slow start enabled, but forced rate was invalid
108
Analog output hysteresis was invalid
109
Analog modulation output type was invalid
110
IAS open rate differential was invalid
111
IAS open step rate was invalid
112
Mix max modulation rate was invalid, % vs. RPM
113
Mix max modulation rate was > absolute max or < absolute min rates
114
Mix modulation range (max minus min) was too small (< 4% or 40 RPM)
115
Fan was limited to its minimum duty cycle
116
Manual rate was > CH max modulation rate
117
Manual rate was > DHW max modulation rate
118
Manual rate was < min modulation rate
119
Manual rate in Standby was > absolute max rate
120
Modulation commanded rate was > CH max modulation rate
121
Modulation commanded rate was > DHW max modulation rate
122
Modulation commanded rate was < min modulation rate
123
Modulation rate was limited due to Outlet limit
124
Modulation rate was limited due to Delta-T limit
125
Modulation rate was limited due to Stack limit
126
Modulation rate was limited due to anticondensation
127
Fan speed out of range in RUN
128
Modulation rate was limited due to IAS was open
129
Slow start ramp setting of zero will result in no modulation rate change
130
No forced rate was configured for slow start ramp
131
CH demand source was invalid
132
CH P-gain was invalid
133
CH I-gain was invalid
134
CH D-gain was invalid
135
CH OFF hysteresis was invalid
136
CH ON hysteresis was invalid
137
CH sensor type was invalid
138
CH hysteresis step time was invalid
139
CH remote control parameter was invalid
140
CH ODR not allowed with remote control
141
Steam P-gain was invalid
142
Steam I-gain was invalid
143
Steam D-gain was invalid
144
Steam OFF hysteresis was invalid
145
Steam ON hysteresis was invalid
146
CH control was suspended due to fault
147
CH header temperature was invalid
148
CH Outlet temperature was invalid
149
CH steam pressure was invalid
150
Steam setpoint source parameter was invalid
151
Minimum water temperature parameter was greater than setpoint
152
Minimum water temperature parameter was greater than time of day setpoint
153
Minimum pressure parameter was greater than setpoint
154
Minimum pressure parameter was greater than time of day setpoint
155
CH modulation rate source parameter was invalid
156
Steam modulation rate source parameter was invalid
157
DHW demand source was invalid
158
DHW P-gain was invalid
159
DHW I-gain was invalid
160
DHW D-gain was invalid

Camus Hydronics ProtoNode FPC-N34 Specifications

General

Brand	Camus Hydronics
Model	ProtoNode FPC-N34
Category	Controller
Language	English