Camus Hydronics ProtoNode FPC-N34 User Manual

Page 80 of 87
ProtoCessor 1991 Tarob Court Milpitas, California 95035 USA Web: www.protocessor.com
Tel: (408) 964-4444 Fax: (408) 964-4425 email: support@protocessor.com
504
Mix outdoor temperature was invalid
505
Mix ODR time of day setpoint was invalid
506
Mix ODR time of day setpoint exceeds normal setpoint
507
Mix ODR max outdoor temperature was invalid
508
Mix ODR min outdoor temperature was invalid
509
Mix ODR low water temperature was invalid
510
Mix ODR outdoor temperature range was invalid
511
Mix ODR water temperature range was invalid
512
Mix demand switch was invalid
513
Mix ON hysteresis was invalid
514
Mix OFF hysteresis was invalid
515
Mix ODR min water temperature was invalid
516
Mix hysteresis step time was invalid
517
Mix P-gain was invalid
518
Mix I-gain was invalid
519
Mix D-gain was invalid
520
Mix control was suspended due to fault
521
Mix S10 (J10-7) temperature was invalid
522
Mix outlet temperature was invalid
523
Mix inlet temperature was invalid
524
Mix S5 (J8-11) temperature was invalid
525
Mix modulation sensor type was invalid
526
Mix ODR min water temperature setpoint was invalid
527
Mix circulator sensor was invalid
528
Mix flow control was invalid
529
Mix temperature was invalid
530
Mix sensor was invalid
531
Mix PID setpoint was invalid
532
STAT may not be a Mix demand source when Remote Stat is enabled
533-539
RESERVED
540
Delta T inlet/outlet enable was invalid
541
Delta T exchanger/outlet enable was invalid
542
Delta T inlet/exchanger enable was invalid
543
Delta T inlet/outlet degrees was out of range
545
Delta T inlet/exchanger degrees was out of range
546
Delta T response was invalid
547
Delta T inversion limit response was invalid
548
Delta T rate limit enable was invalid
549
Delta T exchanger/outlet wasn't allowed due to stack limit setting
550
Delta T inlet/outlet limit was exceeded
551
Delta T exchanger/outlet limit was exceeded
552
Delta T inlet/exchanger limit was exceeded
553
Inlet/outlet inversion occurred
554
Exchanger/outlet inversion occurred
555
Inlet/exchanger inversion occurred
556
Delta T exchanger/outlet wasn't allowed due to stack connector setting
557
Delta T inlet/exchanger wasn't allowed due to stack limit setting
558
Delta T inlet/exchanger wasn't allowed due to stack connector setting
559
Delta T delay was not configured for recycle response
560
Outlet T-rise enable was invalid
561
Heat exchanger T-rise enable was invalid
562
T-rise degrees was out of range
563
T-rise response was invalid
564
Outlet T-rise limit was exceeded
565
Heat exchanger T-rise limit was exceeded

Camus Hydronics ProtoNode FPC-N34 Specifications

General

Brand	Camus Hydronics
Model	ProtoNode FPC-N34
Category	Controller
Language	English