ProtoCessor 1991 Tarob Court Milpitas, California 95035 USA Web:
www.protocessor.com
Tel: (408) 964-4444 Fax: (408) 964-4425 email: support@protocessor.com
Camus ProtoNode Startup
G id
Heat exchanger T-rise wasn't allowed due to stack limit setting
Heat exchanger T-rise wasn't allowed due to stack connector setting
Outlet T-rise wasn't allowed due to outlet connector setting
T-rise delay was not configured for recycle response
Heat exchanger high limit setpoint was out of range
Heat exchanger high limit response was invalid
Heat exchanger high limit was exceeded
Heat exchanger high limit wasn't allowed due to stack limit setting
Heat exchanger high limit wasn't allowed due to stack connector setting
Heat exchanger high limit delay was not configured for recycle response
CH pump output was invalid
DHW pump output was invalid
Boiler pump output was invalid
Auxiliary pump output was invalid
System pump output was invalid
Mix pump output was invalid
DHW plate preheat setpoint was invalid
DHW plate preheat ON hysteresis was invalid
DHW plate preheat OFF hysteresis was invalid
Tap detect degrees was out of range
Tap detect ON hysteresis was invalid
Inlet - DHW tap stop degrees was out of range
Outlet - Inlet tap stop degrees was out of range
DHW tap detect on threshold was invalid
DHW plate preheat detect on threshold was invalid
DHW plate preheat detect off threshold was invalid
Delta T inlet temperature was invalid
Delta T outlet temperature was invalid
Delta T exchanger temperature was invalid
Parameter PCB was switched to backup
Range PCB was switched to backup
Lead Lag ODR boost max offpoint temperature was invalid
Lead Lag ODR boost max offpoint temperature was too low
Mix ODR boost max offpoint temperature was invalid
Mix ODR boost max offpoint temperature was too low
Time to rotate lead boiler to next firing slave
Time to rotate lead boiler to next available slave
Time to rotate lead boiler to first firing slave in order
Time to rotate lead boiler to lowest running slave
Lead boiler was rotated based on new firing sequence order
Lead boiler was rotated based on measured run time
Parameter PCB was switched to backup
Range PCB was switched to backup
Lead Lag steam pressure was invalid
Lead Lag steam setpoint was invalid
Lead Lag steam OFF hysteresis was invalid
Lead Lag steam ON hysteresis was invalid
Lead Lag steam minimum pressure was invalid
Lead Lag modulation sensor was not valid with setpoint source
To Next Page
Loading...
Need help?
General