Canon iPF9000S - Page 32

Troubleshooting Guide
2-20
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(★: Reference fault
isolation procedure
or tool)
Ink insufficient.
Press OK and
replace ink tank.
Ink tank short on ink
A print operation was attempted, but there is
not enough ink left in the tank for the
operation.
(In the small LCD, the arrow ↓ points to the
color in question.)
①Replace the ink.
②Failure of
remaining ink
detection
system.
(Replace the
supply unit
/check the
bundled wires.)
2590
to
259C
Ink insufficient.
Replace ink tank.
Not
Enough
Ink
↓↓↓
↓↓↓
Replace
ink tank
orOnline
to prnt
Reference)
About 5 mL to 40 mL of ink may have been left in the tank when
this warning occurs.
Close the ink tank
cover. Unable to
detect
ink level correctly
25B7
Unable to detect
ink level correctly
The remaining ink falls below the pin check
level while ink tank cover is open.
Close the ink tank
cover.
Note) It doesn’t
recover if the
cover is open
when replacing
the ink tank with a
valid one.
260E Hardware error.
03130031-260E
Turn off printer,
wait, then
turn on again.
Power
On
Again
Gap
Detect
Err
Gap detection failure
Carriage gap calibration has not been
carried out, or gap detection is disabled by
corrupt calibration data.
①Check to see if
the
multisensor
reference
plate (white
patch for batch
correction) is
not soiled and
perform GAP
CALIB (if
soiled, adjust
the part after
replacing it).
②Replace the
multisensor
and perform
GAP CALIB.
③Replace the
carriage unit
and perform
GAP CALIB.
260F Gap error.
Turn off printer.
Power On
Again
Gap
Error
Gap reference plane error
Request to replace an abnormal reference
plane sheet (only in Service mode).
Check the
multisensor
reference plate
(for soiling and
faulty mounting).
Go to Flow 1 in ★
2010 (P3-12)
2618 Hardware error.
03130031-2618
Turn off printer,
wait, then
turn on again.
Vh voltage error Go to ⑩ (all
nozzles on a
single- or
double-head
model not
discharging) in
★T03 (P4-3).