Canon iPF9000S - Page 41

Chapter 2 Indexes by Case
2-29
Panel display
Code
(last 4
digits)
Large LCD
Small
LCD 1
Small
LCD 2
Explanation/Detection sequence
Remedial Action
(★: Reference fault
isolation procedure
or tool)
282A CR MOTOR
TUNING
ERROR :PRESS
OK
Carriage motor identification processing
(rotation adjustment) failed (for Service
mode)
①Check
installation of
carriage or
carriage belt.
②Clean the
carriage main
rail (Do not oil
it.)
③Replace the
carriage motor.
282B CR VIBRATION
ERROR :PRESS
OK
When processing carriage motor
identification (rotation adjustment), carriage
vibration has been detected (for Service
mode).
①Check
installation of
carriage or
carriage belt.
②Clean the
carriage main
rail (Do not oil
it.)
③Replace the
carriage motor.
282D Left printhead
error.
Turn off printer,
wait, then
turn on again.
Printhead error detected (L head only).
Displayed when an abnormal temperature
rise of printhead has been detected to prompt
you to restart.
After restarting,
replace the
printhead L.
2830 Left printhead
error.
Open top cover and
replace the left
printhead.
Printhead error detected (L head only).
Displayed when restarting after detection of
error 282D to prompt you to replace
printhead L.
Replace the
printhead L.
Mail box
nearly full.
Delete unwanted
data
2901
The mail box is
nearly full. Delete
unwanted jobs.
The available size of the permanent area of
the hard disk space has fallen to less than 1
GB.
Reorganize data.
2902 Mail box full.
Now printing
without saving data.
The hard disk has run out of free space,
disabling copy printing or error recovery.
Reorganize data.