From a Computer
8
Register the generated PIN code to the wireless router.
● Register the PIN code on the setup screen displayed in step 1.
● The PIN code must be registered within 10 minutes after pressing with <Yes> selected in step 7.
If an error message is displayed during setup
● Press
and return to step 6.
From the Operation Panel
9
Check that the Wi-Fi indicator is blinking on the operation panel.
● The Wi-Fi indicator blinks when a wireless router is detected.
● When the setup is completed, the screen below is displayed, and approximately 2 seconds later, the Wi-Fi
indicator lights up.
● Wait approximately 2 minutes until the IP address settings of the machine are completed.
Signal strength
● When more than one wireless router is available for connection, the machine connects to the device with
the strongest signal. Signal strength is measured using RSSI (Received Signal Strength Indication).
Reducing power consumption
● You can set the machine to enter <Power Save Mode> based on signals emitted from the wireless router.
Power Save Mode (P. 291)
Network
141
To Next Page
Loading...
