Canon LBP252dw - Testing the Network Connection

If you changed the IP address after installing the printer driver
● If you are using an MFNP port, and the machine and the computer are on the same subnet, then the
connection will be maintained. You do not need to add a new port. If you are using a standard TCP/IP port,
then you need to add a new port. Conguring Printer Ports(P. 168)
*
If you are not sure which type of port you are using, see
Checking the Printer Port(P. 478) .
Testing the Network Connection
1
Press .
2
Use / to select <Network Settings>, and press .
● If the logon screen appears, enter the correct ID and PIN using the numeric keys, and then press .
Logging on to the Machine(P. 34)
3
Select <TCP/IP Settings> <IPv4 Settings> <PING Command>.
4
Enter the IPv4 address of another device on the network, and press .
● If a proper connection has been established, the result is displayed as shown above.
LINKS
Setting IPv6 Addresses(P. 157)
Viewing Network Settings(P. 161)
Conguring WINS(P. 186)
Network
156