Sets the machine to automatically select AES-CCMP or TKIP to match the setting of the wireless router.
<AES-CCMP>
Sets AES-CCMP as the encryption method.
3
Enter the network key that you have written down.
● Enter the network key using the numeric keys, select <Apply>, and press . Entering Text(P. 32)
8
Select <Yes>, and press .
If an error message is displayed during setup
● Press , check whether the specied settings are correct, and return to step 5.
9
Check that the Wi-Fi indicator is blinking on the operation panel.
● The Wi-Fi indicator blinks when a wireless router is detected.
● When the setup is completed, the screen below is displayed, and approximately 2 seconds later, the Wi-Fi
indicator lights up.
● Wait approximately 2 minutes until the IP address settings of the machine are completed.
Signal strength
● When more than one wireless router is available for connection, the machine connects to the device with
the strongest signal. Signal strength is measured using RSSI (Received Signal Strength Indication).
Network
148
To Next Page
Loading...
