● T
o check the settings registered in the key, see
Checking the Registered Settings(P. 135) .
● Scanning starts.
● T
o cancel, press
<Yes> .
You cannot scan while the ScanGear MF is displayed. Close the
scr
een before scanning.
When placing documents in the feeder in step 1 (MF244dw)
When scanning is complete, the save destination folder is displayed on the computer.
When placing documents on the platen glass in step 1
When scanning is complete, follow the procedure below (when le format is PDF).
1
If there are additional pages of documents to be scanned, place the next document on the platen
glass, and pr
ess
.
● Repeat this step until you nish scanning all of the pages.
● When ther
e is only one page to be scanned, proceed to the next step.
2
Use
/ to select <Finish Scanning>, and press .
● The save destination folder is displayed on the computer.
About the save destination folder
● By default, the scanned data is saved to the [My Documents] folder. A subfolder named with the scanning
date is cr
eated, and the data is saved to that folder.
● You can change the save destination from MF Scan Utility. For more information, click [Instructions] on MF
Scan Utility.
LINKS
Scanning from the Machine(P. 130)
Using the Machine as a Scanner
136
To Next Page
Loading...
