To Next Page

To Previous Page





8IBU5P%P*GUIF$VUUFS*T(FUUJOH#MVOU

 $IBOHJOHUIFDVUUJOHEFQUI

If the cutter does not cut tube or label tape properly, try changing the cutting depth. The cutting depth for half

cuts and for full cuts can be adjusted as described below. In addition, these adjustments can be made separately

for each type of print media.

If half cuts are made so deeply that they completely cut through the tube, adjust cutting to a shallower depth.

Note that a deeper cutting depth will cause the cutter and the cutter receiver to wear out more quickly.

FY 'VMMDVUTPGMBCFMUBQFBSFOPUDPNQMFUFDVUTTPJODSFBTFUIFDVUUJOHEFQUICZPOFTUFQ



 1SFTT<"EKVTU>

The Print Media display appears.•



 1SFTT<

▲

>PS<

▼

>UPTFMFDUi-BCFMuBOEUIFOQSFTT<&OUFS>

Select the print media for which the adjustment is to be made.

Press [Enter] to display the Adjustment display.

The cutting depth can be set separately for each type of print media.

•



 1SFTT<

▲

>PS<

▼

>UPTFMFDUi'VMMDVUuBOEUIFOQSFTT<&OUFS>

The Full Cut display appears.•

Canon Mk2500 User Manual

Questions and Answers: