*OTFSUQMBUF
Plates are not provided with the printer; they must be purchased separately. The printer can print on from 8.0mm
to 10mm plates. Note that the printer will not print properly on plates that are bumpy, dirty or of uneven
thickness.
0QFOUIFDPWFS
*OTFSUBQMBUF
Insert the plate into the intake, and push it in
until it touches the transport roller 2.
•
$MPTFUIFDPWFS
Close the cover completely so that it clicks shut.
Printing may not be performed properly if the surface of the plate
is unsuitable.
•
1BZBUUFOUJPOUPXBSQPGUIFQMBUF
Insert the plate with the warp oriented as shown in the
figure. If the plate is inserted in a wrong orientation, it
can jam and cause a feed error.
5SBOTQPSUSPMMFS
To Next Page
Loading...
Need help?
General