MAX370M
8
conditions that may affect its operation. A guard or other part that is damaged should be
properly repaired or replaced.
14. Disposing of wasted material.
Disposing waste material and waster lubricating oil shall obey the local regulation and be
careful.
15. Fire extinguisher.
Workshop of used shall be with the fire extinguisher or other devices according to the local
safety regulations and be careful.
16. Stand on proper position for operation.
Please stand in front of the machine for operation.
17. Use recommended ancillary equipment.
Consult of the instruction manual of drawing for recommended accessories. The use of
improper accessories may cause risk of injury to persons. If ancillary equipment is removed the
original guards or safety devices shall be replaced.
18. Reduce the risk of unintentional starting.
Make sure switches of control panel are OFF position before operating.
19. Never leave machine running unattended.
Turn the power off from the hand-hold disconnecting device. Do not leave machine until it
comes to a complete stop.
20. Make sure machine is disconnected from power supply.
Make sure machine is disconnected from power supply before started the normal
maintenance and service, adjustment, or repairing.
21. Reaction with emergency situation.
This machine provides two emergency buttons. One is self-latching push-button on the control
panel of access position. Other emergency buttons are position on the front side on the
machine near in-feed working area. The emergency button is colored red and yellow
background. After emergency stop, follow the normal start up procedure and suitable
operation to obviate the hazard. Please see the afterward pages of emergency stop position
diagram.
22. Never open the protective cover or the machine door while the machine is running.
23. When the machine is out of order while running, shut it down and to call servicemen for help
as soon as possible.
24. Wear ear protectors (plugs or muffs) during extended periods of operation.
25. Remove adjusting keys and wrenches before turning machine on. Be sure that the keys and
adjusting wrenches have been removed and all the nuts and bolts are secured.
26. After switching off the saw motor, allow the saw blade to stop freely. Never attempt to stop
the cutting by hand or other objects.
27. Never cut the wood plate if there is no completed width or too small.
To Next Page
