Maintenance
150
Capron - 3141417 - 03/20 - EHG-0021-02EN
13
13.3 Maintenance work
As with every machine, this vehicle requires maintenance. The extent and
frequency of the maintenance work required depend on conditions of opera-
tion and use. More difficult operating conditions make it necessary to service
the vehicle more often.
Have the base vehicle and the appliances serviced at the intervals specified
in the corresponding instruction manuals.
13.4 Replacing bulbs, external
Bulbs and light fittings can be extremely hot. Therefore, allow lamp to
cool down before changing bulbs.
Store bulbs in a safe place inaccessible to children.
Do not use any bulb that has been dropped or which shows scratches
in its glass. The bulb might burst.
A new bulb should not be touched with the fingers. Use a cloth when in-
stalling the new bulb.
Only use bulbs of the same type and with the correct wattage.
If LEDs in lamps are defect, contact an authorised dealer or service cen-
tre.
Different types of bulbs are used in the vehicle. Below, we have described
how to change the different types of bulbs.
Fig. 149 Types of bulbs
Pos. in
Fig. 149
Fixture type/bulb
type
Changing
1 Plug-in fixture To remove, pull out the bulb
To mount, push the bulb into the socket with
gentle pressure
2 Bayonet socket
To remove, press the bulb down and turn in
an anticlockwise direction
To insert, place the bulb in the socket and
turn in a clockwise direction
3 Cylindrical bulbs
To remove and to insert, carefully bend the
contacts of the lamp holder outwards
4 Halogen bulb To remove, release retaining springs
After inserting, hook the retaining springs
again
T
pes of bulbs
To Next Page
Loading...
Need help?
General
