Maintenance
Capron - 3141417 - 03/20 - EHG-0021-02EN
153
13
13.5 Replacing bulbs, internal
Bulbs and light fittings can be extremely hot. Therefore, allow lamps to
cool down before changing bulbs.
Shut off the power supply on the safety cut-out in the 230 V fuse box
before changing bulbs.
Store bulbs in a safe place inaccessible to children.
Do not use any bulb that has been dropped or which shows scratches
in its glass. The bulb might burst.
Do not replace the LEDs in lamps with standard light bulbs. Risk of
fire due to intense heat build up.
A new bulb should not be touched with the fingers. Use a cloth when in-
stalling the new bulb.
Only use bulbs of the same type and with the correct wattage.
If LEDs in lamps are defect, contact an authorised dealer or service cen-
tre.
The lamps shown in this section are examples. Depending on the model,
the lamps may differ from the type displayed here. The examples are in-
tended to point out the possible procedures for changing bulbs in lamps.
13.5.1 LED lamps
Fig. 154 LED ceiling lamp (example)
Fig. 155 Recessed LED light
(example)
Fig. 156 LED lamp (example) Fig. 157 Awning light
LED lights have a very long life. It is not normally necessary to replace a
light.
Contact a dealer or service centre.
Changing bulbs:
To Next Page
Loading...
Need help?
General
