What to do if AC power fails in CaptiveAire TANK?
If there's an AC power failure, it means the 120V AC input power supply has been interrupted. Verify constant input power between H1 and N1. Check wiring to L/N terminals on PS-02. Locate and repair any faulty wiring in the circuit.
Why is the audible alarm on in my CaptiveAire TANK?
The audible alarm is activated because the fire system has been triggered. To resolve this, first, verify that the fire is extinguished, and then reset the fire system.
What does it mean if a fault code is flashing on the “Fire System Activated” light of my CaptiveAire TANK?
If a fault code is flashing on the “Fire System Activated” light, it means a fault has been detected in the Fire Protection System. Count the flashes and refer to Table 16 to identify the specific fault.
Why doesn't the gas valve close on my CaptiveAire TANK?
If the gas valve does not close, it may be due to debris on the gas valve seal. Fully clean the gas valve and strainer to resolve this issue.
What causes a Supervised Loop Fault in a CaptiveAire TANK Fire Extinguisher?
A Supervised Loop Fault can be caused by several issues: * An open supervised loop between terminals 21 and 24. Locate and repair the faulty wiring in the 21-24 supervised loop. * An open supervised loop between terminals 22 and 23. Locate and repair the faulty wiring in the 22-23 supervised loop. * An open supervised loop push-station (terminals 101 and 104). Locate and repair the faulty wiring in the 101-104 supervised loop. * An open supervised loop push-station (terminals 102 and 103). Locate and repair the faulty wiring in the 102-103 supervised loop.
What to do if the exhaust fan is on but the supply fan won't start in my CaptiveAire TANK?
If the exhaust fan is running but the supply fan won't start, it could be due to: * A broken supply fan belt. If this is the case, replace the fan belt. * The fire system not being armed. The fire system distributor must arm the fire system.
How to turn off CaptiveAire Fire Extinguisher system that won't turn off?
If the fire system will not turn off, it could be due to two reasons: 1. The duct sensor is hot, meaning heat has activated it. Remove the heat source or allow the system to extinguish the fire. Once the heat source is gone, press the reset button on the electrical control package. 2. The Remote Manual Actuation Device has been pushed. Reset the remote push station (twist clockwise until reset) after the fire is out, and then press the reset button on the electrical control package.
Why is the audible alarm on my CaptiveAire TANK activated?
The audible alarm is activated because the fire system has been activated. To resolve this, first verify that the fire is completely out, and then reset the fire system.
Provides a general description of the fire suppression system's function and components.
Explains the typical installation and mounting of agent storage cylinders within the cabinet.
Step-by-step guide for replacing a faulty primary actuator kit.
Instructions for replacing a malfunctioning secondary valve actuator.
Details flushing the network using a spare or test cylinder.
Instructions for safely removing cylinders from the system for maintenance or storage.
General| Agent Type | Wet Chemical |
|---|---|
| Application | Restaurant, Commercial Kitchen |
| Extinguishing Agent | Wet Chemical |
| Operating Pressure | 100 psi |
| Discharge Time | 40 seconds |
| Weight | 22 lbs |
| Material | Steel Cylinder |
| Standards | ANSI/UL 8, ULC S554, NFPA 10 |
To Next Page