7. User menu and unit configuration
The following paragraphs describe the gaSteam programming menus. The screen index at the top right
corresponds to the sequence in each menu in order to reach the specific page.
7.1
Main menu
7.1.1 Clock menu
The Clock menu is used to set the time, date and time zone. Setting the time zone will automatically
update standard/daylight saving time. To access, enter the system menu and then click the clock icon:
Fig.7.a
7.1.2 Inputs/outputs
The Inputs/outputs menu is used to read the status of the inputs and outputs and check unit operation
and status.
From the system menu, enter the “Input/Output” menu:
Fig.7.b
Parameter Description
Analogue inputs
Values read by main probe, limit probe, boiler water temperature, feedwater
conductivity.
Digital inputs Read status of remote On/Off, levelsensor float position, foam sensor.
Analogue outputs Read current production
Digital outputs Read status of unitOn/Off, contactor, drain pump, fillvalve, SSR/fan
In/Out - WPrb 1
In/Out wireless probe 1
Read temperature and/or humidity values
Read value of level signal and battery level on probe 1
In/Out - WPrb 2
In/Out wireless probe 2
Read temperature and/or humidity values
Read value of level signal and battery level on probe 2
In/Out - WPrb 3
In/Out wireless probe 3
Read temperature and/or humidity values
Read value of level signal and battery level on probe 3
In/Out - WPrb 4
In/Out wireless probe 4
Read temperature and/or humidity values
Read value of level signal and battery level on probe 4
60|7. User menu and unit configuration
gaSteam - UG +0300090EN rel. 1.2– 09.10.2018
To Next Page
Loading...
