Unit status Description
Ready for
backup
the unit is ready and awaiting to start operation if there is a fault on the main unit.
Manual mode
test mode for commissioning and to check functions (for example: activate drain pump, activate fill
valve...)
Warning warning notification
Preheating the unit is preheating the water in the boiler
Startup preheat. at start-up, the unit heats the water to reach the production request
Autotest the unit is running the autotest
Inactivity drain water drain due to inactivity or periodically, the drain pump is operating
Tab.6.d
6.5.7 Descriptive icon of humidifier status
Graphic display of unit status via animated icons. The status may be:
Fill (fill valve active)
Drain (drain pump active)
Steam production
Minimum water level in the boiler (yellow and red LEDs on);
Water level above the maximum in the boiler (green LED on);
6.6
Complete
programming
tree
Below is the complete tree of the settings menu. The screen index at the top right corresponds to the
sequence in each menu in order to reach the specific page. There are two levels of access: Installer and
Service. To login to the settings menu, use the following passwords:
l service: 0044;
l installer: 0077.
Menu A. Clock
Index Description Level
A01 Set the time, date and time zone
Installer
Service
Menu B. Time bands (scheduler)
Index Description Level
B01 Enable time bands
Installer
Service
B02
(visible if time bands are enabled)
Set the time bands: day, on time,
off time
Installer
Service
Menu C. Alarm thresholds
Index Description Level
C01
Set alarm thresholds
Low humidity/temperature alarm threshold
High humidity/temperature alarm threshold
Limit humidity/temperature alarm threshold
Installer
Service
To Next Page
Loading...
