P/N L tot max kg/h lbs/hr
DP045D30R0 427 8 17.62
DP060D30R0 596 12 26.43
DP085D30R0 850 18 39.65
DP105D30R0 1048 18 39.65
DP125D30R0 1245 18 39.65
DP165D30R0 1640 18 39.65
DP085D40R0 834 25 55.07
DP105D40R0 1015 35 77.09
DP125D40R0 1222 45 99.12
DP165D40R0 1636 45 99.12
DP205D40R0 2025 45 99.12
DP035D30RH 343 5 11.01
DP045D30RH 427 8 17.62
DP060D30RH 596 12 26.43
DP085D30RH 850 18 39.65
DP105D30RH 1048 18 39.65
DP125D30RH 1245 18 39.65
DP165D30RH 1640 18 39.65
DP085D40RH 834 25 55.07
DP105D40RH 1015 35 77.09
DP125D40RH 1222 45 99.12
DP165D40RH 1636 45 99.12
DP205D40RH 2025 45 99.12
Important:
1. mount the distributor with a slight slope (at least 2°, to facilitate condensate drainage);
2. the L- shaped support is supplied with steam distributor models from DP085* to DP205*. For
shorter lengths, the support can be supplied as an option (P/N 18C478A088).
3.3 High-
efficiency linear
distributors for
air ducts or AHUs
High-efficiency linear distributors (sold separately), can be used in all cases where the formation of
condensate needs to be reduced inside the distributor itself. All the information provided in the
paragraph on linear distributors still applies; the dimensions and diameters are shown below.
Fig.3.c
Key:
1. L-shaped mounting bracket (where featured)
2. flange gasket
3. steam inlet (ØA)
4. condensate drain (ØB)
5. flange screw (see technical leaflet supplied)
26|3. Steam distribution
gaSteam - UG +0300090EN rel. 1.2– 09.10.2018
To Next Page
Loading...
