Index Parameter Description
Ec02 Limit/second probe
Limit probe configuration;
Default:
Enable: Enabled (depending on the type of control)
Type: 0-10V
Minimum: 0% rH
Maximum: 100% rH
Offset: 0
Enable Al (enable alarms): YES
Delay: 120 seconds
Possible settings:
Type: 0-10V/0-1V/NTC/4-20mA/0-20mA/2-10V
Minimum: 0-100% rH
Maximum: 0-100% rH
Offset: 0
Enable Al (enable alarms): YES
Delay: 120 seconds
The same explanations provided in the previous paragraph also apply here.
7.4.3 Wireless probes (Installer menu)
Configuration of the wireless probes involves defining the weight of each probe; for further details on the
averages see paragraph 7.2.2 “Weighted average of the probes”. Screen Ec03 can be used to deactivate,
activate as main probe or limit probe each of the four possible wireless probes.
Index Parameter Description
Ec03 Wireless probes
Wireless probe configuration (main and limit)
Default:
Probe 1: disabled
Probe 2: disabled
Probe 3: disabled
Probe 4: disabled
Possible settings: disabled, main probe, limitprobe
To configure the wireless probes, weights and communication times, use screens Ec04, Ec05, Ec06 and
Ec07, depending on the number of probes connected.
Index Parameter Description
Ec04
Ec05
Ec06
Ec07
Wireless probe 1
Wireless probe 2
Wireless probe 3
Wireless probe 4
Configure probe weight and communication times;
Default:
Weight: 100
Transmission time: 10 s
Disconnection delay: ms
Range:
Weight: 0-100
Transmission time: 5-3600 seconds
Disconnection delay: ms
Note:
l if wanting to use two wireless probes, simply set “humidity (one probe)” control (Ea01) and then
activate the two wireless probes on screen Ec03;
l “humidity+limit” control (Ea01) can also be used, in this case on screen Ec03 choose which of the
four wireless probes is the limit, and set the others as main;
l “humidity+limit” control (Ea01) can also be used, in this case on screen Ec03 choose which of the
four wireless probes is the limit, and set the others as main;
72|7. User menu and unit configuration
gaSteam - UG +0300090EN rel. 1.2– 09.10.2018