7.8.2 Set the language (Service and Installer menu)
The first time that the unit is powered on, the menu language needs to be selected. To change the
language, go to screen Eg02. Press “ENTER” and UP/DOWN to set, ESC to exit without changes.
Index Parameter Description
Eg02 Language
Set the language.
Default: English
Possible settings:
1. English
2. Italiano
3. Deutsch
4. Français
5. Español
7.8.3 Set the unit of measure (Installer menu)
Screen Eg03 is used to select the units of measure: International (°C, kg/h) or Imperial (°F, lb/h). In
addition, the language selection screen when starting can be disabled.
Index Parameter Description
Eg03
Unit of measure and language
when starting
Select the units of measure. Show change language when starting.
Default:
units of measure: depending on unit P/N
show change language when starting: YES
Possible settings:
units of measure: International, Imperial
show change language when starting: YES, NO
7.8.4 Set and change passwords (Service and Installer menu)
Screen Eg04 is used to change and/or set the Service and Installer passwords.
The passwords are 4-digit numbers.
The default Installer password is: 0077
The default Service password is: 0044
Index Parameter Description
Eg04 Change passwords
Set and change the passwords
Default:
Installer: 0077
Service: 0044
7.8.5 Factory reset (Service and Installer menu)
To reset all parameters to the default values, use screen Eg06.
Index Parameter Description
Eg06 Inst. default
Unit factory reset.
Remarks: follow the directions shown on the display
Confirmation will be requested before resetting the values
Important: when performing a reset, all the control settings will be lost and the values will return to
the factory defaults.
To Next Page
Loading...
