Spostare il terzo punto sui fori (1) o (3) se:
Spostare il terzo punto sui fori (1) o (2) se:
Move the third point onto holes (1) or (3) if:
• Lift activity is excessive or erratic with draft control.
• Implement rear end raises too much when being
lifted. The lowest position oers maximum lifting
height but a smaller force, and is recommended
when working with a plough.
• Set draft control lever range is too small.
Move the third point onto holes (1) or (2) if:
• The lift unsatisfactorily responds to draft controls
and engine rpm drops too much before lifting the
equipment.
• Equipment rear end lowers or is dragged on the
ground when equipment is lifted.
Lower equipment down to remove weight from hitch.
5
revision 0 date: 07/19 doc. AG525990
To Next Page
Loading...
