6
revision 0 date: 07/19 doc. AG525990
6.6.7 - Clutch pedal stroke adjustment 6.6.7 - Regolazione della corsa del pedale
frizione
Nota: nel caso in cui anche il terzo foro presente
sulla forcella (4) non fosse suciente per regolare
la corsa del pedale è necessario sostituire la
frizione.
1. Loosen the screws (1) and remove the cover (2).
2. Turn the nut and locknut (7) to adjust the travel of
the lever (5).
3. Fully depress the clutch pedal 10 times.
4. Select a gear and ensure there is no clutch drag.
5. Otherwise, loosen the nut (3).
6. Remove the fork (4) from the fastening pin located
on the clutch lever (5).
7. Insert the fastening pin located on the clutch lever
(5) into the hole (6).
8. Tighten the nut (3).
9. Repeat the operations in points 3 and 4.
10. If there is still insucient travel, insert the
fastening pin located on the clutch lever (5) into
the hole (8) as described in points 5 to 9.
Note: if the third hole on the fork (4) still does not
provide sucient travel to adjust the stroke of the
pedal, the clutch must be replaced.
To Next Page
Loading...
