13
Table 27
: Minimum size of drain valves
.................................................................................................................... 91
Table 28
: Design parameters for pipe supports
....................................................................................................... 98
Table 29
: Minimum dimension of flat iron rods and clips
........................................................................................ 99
Table 30: Light Hazard occupancies (A.1)
............................................................................................................. 111
Table 31: Ordinary Hazard occupancies (A.2)
....................................................................................................... 111
Table 32: High Hazard Process occupancies (A.3)
................................................................................................ 114
Table 33
: Categories as a function of
stored materials configuration (B1)
......................................................... 117
Table 34: Stored products and categories (C.1)
.................................................................................................. 120
Table 35: Stored products and categories (continued (C.2))
............................................................................... 121
Table 36: Stored products and categories (continued( C.3))
............................................................................... 122
Table 37
: C
values for various types of
pipe (G1)
.................................................................................................. 132
Table 38
: Equivalent length of
fittings
and valves (G2)
.......................................................................................... 134
Table 39
: Accuracy of hydraulic calculations (G3)
.................................................................................................. 134
Table 40
: Location of
design points – LH (G4)
....................................................................................................... 135
Table 41
: Location of
design points - OH, HHP and
HHS (G5)
.............................................................................. 135
Table 42
: Range pipe diameters for LH installations (G6)
...................................................................................... 136
Table 43
: Maximum friction loss between control valve set and any design point – LH (G7)
............................ 136
Table 44
: Pressure loss for design flow rates in LH installations (G8)
.................................................................. 137
Table 45
: Range pipe diameters for OH installations (G9)
..................................................................................... 137
Table 46
:
Distribution
pipe diameters in OH installations (G10)
........................................................................... 138
Table 47: Range pipe diameter for HH installations with pressure and flow characteristics as given in
Table 8 (1 or 2)(G11)
............................................................................................................................................... 140
Table 48
:
Distribution
pipe
diameters
downstream
of
the
design
point
in
HH
installations
with
pressure
and
flow characteristics as given in Table 8 (1) (G12)
................................................................................................... 140
Table 49
:
Distribution
pipe
diameters
downstream
of
the
design
point
in
HH
installations
with
pressure
and
flow characteristics as given in Table 8 (2,3
or 4) (G13)
......................................................................................... 140
Table 50
:
Range
pipe
diameters
of
HH
installations
with
pressure
and
flow
characteristics
as
given
in table
7 (3
or
4) (G14)
......................................................................................................................................................... 141
Table 51
:
Minimum sprinkler discharge pressure and minimum
sprinkler K factor (G15)
................................. 143
To Next Page
Loading...