20
User’s Manual
CellaVision
®
DM1200
Slide ID
The Slide ID is the barcode printed on the slide's label.
Note! The slide ID may not begin with ‘PB’ or ‘BFS’.
When processing a slide the system searches for order data in the following order:
1. In the database, unsigned orders with the same Order ID.
2. In the database, pending orders.
3. From the LIS.
4. Default values defined in the Analysis tab in Settings.
2.4 Loading Slides into a Magazine
Load the slide into the magazine with the barcode upwards and towards the open
end. 12 slides can be loaded into a magazine. The slide positions in the magazine
are numbered 1-12 from the bottom up. Make sure that slides are fully inserted in
the magazine before using the magazine.
Use only clipped/round/beveled corner slides. Failing to do so may cause jams and
excessive wear on magazines and the system.
Note! The same magazine can be used up to 100 times. When this limit is reached
a warning is shown.
If you want to process an already processed slide, carefully wipe the oil off and
make sure the barcode is clean and undamaged.
To Next Page
Loading...