Page 19
Programming Single Unit Overview
Programming Single Unit Overview
(NPB / Single Family Residence ONLY)
You can send commands directly to the unit from your phone without
being in programming mode. This feature is only available from a
single-family residence or a manager who is sharing a phone line with
the unit.
Sending Direct Commands from the Resident’s Phone
To Enter a Direct Command from a Residence Phone:
1
Lift the receiver and press
NOTE: If multiple units are sharing the same phone line, then a Unit ID Code (1-7) will need to be
entered at this time. See next page for more information about Multiple Unit Sites.
The unit is now ready to allow direct commands only!
Example 1:
Enters direct command mode
Example 2:
Enters direct command mode for unit three
To Next Page
Loading...
