Page 35
Makes Entry code length 5 digit maximum.
Example:
1 2
Entry Codes
Entry Codes
Set an Entry Code Length
Factory Setting: 4 Digits
1
Press Then
2
Enter New Entry Code length (3-9 digits). Then (#)
Important: You will not be able to decrease the Entry Code length if codes already exist that
are more than the attempted decrease length. For example, you will not be able to decrease
a code from 5-digits to 4-digits if 5-digit codes already exist.
If you increase the Entry Code length, all existing codes will increase with leading zeroes for
every digit increase. For example, if you increase the length to 5 digits, an existing Entry
Code of 4556 will now be 04556. This value correlates with directory code length. The entry
code length must always be one (1) digit greater than the directory code length.
You will not be able to decrease the Entry Code length if it conflicts with the Directory Code
length.
Add, Edit or Delete Entry Codes
When adding or editing entry codes, note the following:
• Keep a record of each Entry Code you assign. In particular, write down the resident names
associated with each code. This will help when adding, editing or deleting Entry Codes later.
• Each assigned Entry Code must be entered with the set amount of allowable digits (3-9). For
example, if you assign "4578" as a resident’s Entry Code, but the system is set for 5 digits, the visitor
will have to enter "04578" to enter the building.
Add a Basic Entry Code:
1
Press Then
2
Enter Entry Code (3-9 digits). Then (#)
Add an Entry Code ONLY. For adding or editing full function Entry Codes (i.e., codes with
additional options such as use schedules, door assignments, etc.). See next page.
Example:
Adds Entry Code "5400".
21
NOTE: A basic Entry Code will be active and unlock all controlled doors, with no time constraint
(i.e., can be used 24 hours a day, 7 days a week).
NOTE: Factory Setting for Entry Code
Length is 4 digits (See “Entry Code
Length” above)
50
7
To Next Page
Loading...
