Page 8
Quick Reference Guide
Quick Reference Guide
Quick Reference
Page Description of Task
Programming
Number
Factory
Setting
Programming
Procedure
To enter programming mode from the keypad
Press *** and the 6-Digit Password (audio feedback will be heard)
Exiting programming mode allows changes to take effect
Important:
• The Pound Key (#) must be used as Data Field Separator and to Save Date at the end
of the sequence.
• Time must be entered using a 24-hour format (8AM=0800; 3PM=1500 etc.).
• Audio Feedback: Programming input is valid. Audio Feedback: Input is not valid.
• If you make an error during an entry, press the asterisk key (*) to begin again.
105 54 Enable or Disable Anti-Passback Enabled 105 # (0=disable; 1=enable) #
Forgiveness at Midnight
109 58 Override Telephone Disabled 109 # (0=no; 1=yes) # Default is “No”
Company Answering Service
110 59
Set a Phone Number’s No Delays 110 # (directory code) # (phone extension
Extension Delay Time delay) # (call forward extension delay) #
111 20
Verify Unit Number 111 #
113 58 Dial "0-9" First to Get Disabled 113 # (0=disable; 1=enable) #
an Outside Line Using a
(0-9, when enabled) #
Automated Phone System
115 57 Set Alternative Prefixes Normal 115 # (normal-00, mixed-01, asterisk-02,
pound-03, number-1n) # each unit in chain must
have same setting
116 60 Change the Visitor 9,5,3, 116 # (activate door 1) # (activate door 2) #
Call Response Keys 7,2,1,* (activate door 3) # (activate door 4) # (call wait
toggle) # (extend talk time) # (hang up and deny
access) #
120 67 Talk through the 120 #
EL Models Speaker
121 68 Cycle Door 121 # (door 1-4) #
122 68 Toggle Door Open/Close Until 122 # (door 1-4) # (end time=hhmm) #
123 68 Get Door Status 123 # (door 1-4) #
124 68 Release Door 124 # (door 1-4) #
125 68 Enable/Disable Call Forwarding 125 # (0=disable; 1=enable) #
For
Residence
126 68 Enable/Disable Do Not Disturb 126 # (0=disable; 1=enable) #
For
Residence
141 33 Directory Code Display Option/ 0, 1, 141 # (directory code) # (hidden attribute option) #
Resident Display Option 2 or 3
(hidden option; 0=show name and code, 1=name
only, 2=code only, 3=hide) #
201 31 Delete ALL Directory Codes
201 # 101010#
202 38 Delete ALL Entry Codes 202 # 101010#
203 42
Delete ALL Cards
203 # 101010#
204 47 Delete ALL Transmitter Codes
204 # 101010#
205 52 Delete ALL Time Zones
205 # 101010#
206 71 Delete ALL Access 206 # 101010#
Codes from Database
To Next Page
Loading...
