Charlescraft NBR BBM3 - ABOUT YOUR BREADCHEF; Control Panel and Operation

ABOUT YOUR BREADCHEF
This section will help you become fami liar with your Charlescraft BreadChef. Review this information thoroughly
before baking your first loa f.
SELECT BUITON
Pressing this button lets you select which MODE you des ire. Each time you press the SELECT button , the MODE
will advance. (See next section for explanation of different modes.)
CAPACI1Y BUITON
Press thi s button to select 1, 1 1/2 or 2 Lb loaf size.
START BUTfON
Push and hold until beep sounds to start your bread maker. You mu st SELECT de si red mode before pushing
START button.
TIMER SET
Th is button allows you to program your breadmaker to bake bread for completion at a later time. You can only use
the timer after pressing SELECT to determine the mode. To set the timer press and hold the button continuously
The c lo ck will advance showing the amount of time left until COMPLETION. The clock advances in 10 minute
increments only and can not be set for more than 13 hours.
Example: If it is 8:30p.m. and you want bread ready at 7:00a.m.:
1.Cornbine all ingredients in baking pan as per recipe.
2.P iace pan securely ins i de b readma ker .
3.Ciose lid .
4.Press SELECT to desired mode and CAPACITY to lo af size.
5. Press TIMER SET until display reads "10:30" since it is 10 hours and 30 minutes from the time you press
START until the desired completion time .
6.Press START. The colon on the display will fla sh and tile timer will start to count backwards by minutes unti
the correct time for the machi ne to start is reached. Your bread maker will then go through all the required
stages to provide you with a fresh loaf of bread at the time you selected it to be ready.
DO NOT USE T IM ER IF YOU ARE USING FRESH INGREDIENTS (i.e., MILK, CHEESE, EGGS etc.).
IF YOU USE TIMER FOR RECIPES REQ UI RING ADDITION OF INGREDIENTS AT THE FRUIT SIGNAL,
THESE I NGREDIENTS MAY BE CRUSHED DURING INIT IA L KNEADING.
STOPBUITON
Push this button until you hear a beep to stop all functions. Always press STOP after removing bread from
machine. Otherwise the heat er will continue to operate for the " keep warm" period.
CHANGE YOUR MIND?
To erase all settings, p ress STOP and hold until "0:0 0" is displayed.
WARNING SIGNALS
If the display shows "H:E3", t he i nternal temperature of the bread maker is too warm. Press STOP until you hea r
beep, then remove the bread pan and leave li d open for 10-20 minutes to allow oven to cool.