CF Control Settings
The solar absorber must be filled with water to be able to put the solar system into
operation.
13
For further information refer to the product assembly and service instructions for the solar system.
CAUTION: The CF Control 100 deactivates the solar absorber when the adjusted
set point for the pool water temperature is reached. It is possible
therefore that the cooling of the collector is not always sufficient,
which applies especially to hot countries. The customer must
safeguard against a possible overheating that could damage the
solar system.
13
NOTE: If you do not want the solar collector to be deactivated, adjust the set point
for the pool water to a value that is above the measured temperature of the water
To Next Page
Loading...