ChemoformGroup CF Control 100 - Factory Settings (Default Values); Redox Measuring and Control Part; Ph Measuring and Control Part

CF Control 100 Technical data
07/2017
Page
51
14.2 Factory settings (default values)
14.2.1 Redox measuring and control part
Set point
600 mV
P-band 100 mV
Control response
Operating mode pulse interval
Minimum pulse in case of pulse interval,
if adjusted
1 sec.
Period in case of pulse interval, if
adj
usted
30 sec.
Pulse frequency, if adjusted
7200 pulses/min
Pulse duration in case of pulse
frequency
250 ms constant
Permanent
dosing time monitoring
60 minutes
Switch
-
on delay
5 minutes
Permanent monitoring of dosing quantity
0 (deactivated)
Dosing
capacity
3 litres
14.2.2 pH measuring and control part
Setpoint
7.2
P
-
band
0.5 pH
Slope of pH probe
58 mV/pH
Zero point of pH probe 7.0 pH
Temperature compensation
28 °C
Switching point hysteresis
0.1 pH
Control response
Operating mode pulse interval
Minimum pulse in case of pulse interval,
if adjusted
1 sec.
Period in case of pulse interval, if
adjusted
30 sec.
Pulse frequency, if adjusted
7200 pulses/min
Pulse duration in case of pulse
frequency
250 ms constant
Permanent
dosing time monitoring
60 min
utes
Switch
-
on delay
5 minutes
Permanent monitoring of dosing
quantity
0 (deactivated)
Dosing capacity
3 litres