ChemoformGroup CF Control 100 - The Measuring Cell

60 pages

Save Page as PDF

To Next Page

To Previous Page

Operating instructions

CF Control 100

Page

02/2017

3.6 The measuring cell

Water inlet

Aperture for ph and

redox electrodes

Cable for sample

water deficiency

Water outlet

Swimmers pool

Main Page

Table of Contents3
General Information6
Notes in Bold6
Warranty6
Safety Instructions7
Transport Damage7
Information about Carbonate Hardness (CH)8
Description9
Equipment / Features9
Installation10
Checking the Delivery10
Assembly of the System10
Installation Drawing "Closed Sample Water System11
Installation Drawing Wall Mounting Plate with Compact Measuring Cell13
Connecting the Measuring Cell14
The Measuring Cell16
Electrodes17
Connection of Dosing Pumps17
Dosing Points R 1/417
Ph Reduce / Ph Raise18
Container Empty Message18
Sample Water Deficiency Sensor18
Heating / Solar Heating18
Electrical Connection20
Opening the Unit20
Terminals21
Connections of Filter Pump23
Connection Heating / Solar Heating23
Device Description24
Operation and Functions25
Changing the Setting Parameters (Example)25
Table of Setting Parameters26
Factory Setting26
Explanations of Setting Parameters28
Code [Parameter 0]28
Set Points [Parameters 1, 4, 9]29
Time [Parameter 4]29
Switching Marks [Parameters 21 - 37]29
Release Dosing [Parameters 80, 81]29
Release Heating [Parameter 82]29
Slope of Probe [Parameter 86]29
Zero Point Probe [Parameter 87]29
P-Band [Parameters 2, 5]30
Switch-On Delay [Parameter 10]30
Maximum Dosing Time (Dosing Time Monitor) [Parameters 11, 12]30
Maximum Daily Dosing Quantity [Parameters 15, 16]31
Dosing Capacity of Pumps [Parameters 88, 89]31
Code for Calibration [Parameter 92]31
Calibrating Ph Electrode and Chlorine Value32
Calibrating the Ph Electrode32
Querying the Slope / Zero Point of the Ph Electrode [Parameters 86, 87]33
Setting the Disinfectant Content33
Setting the Heating and the Solar Heating34
Reading the Water Temperature [Parameter 7]34
Setting the Temperature Set Point [Parameter 9]34
Activation of the Heating35
Changing from Heating Control to Solar Heating Control (Parameter 94)35
Reading the Temperature of the Solar Sensor [Parameter 8]35
Activation of the Solar Heating [Parameter 94]36
Control of the Filter Pump38
Setting the Time [Parameter 40]38
Setting the Filter Times Switching Marks [Parameters 20 - 37]38
Factory Settings39
24H Operation40
Commissioning41
What to Do before Commissioning the System41
Commissioning42
Activating the Complete System42
Control Limits42
Dinoaccess Remote Visualization / Remote Control (Option)43
Reset of Wifi Settings43
Troubleshooting43
Maintenance and Servicing44
Cleaning and Calibrating the Electrodes44
Cleaning the Measuring Cell45
Wintering45
Alarm Messages46
List of Error Messages46
Resetting of Alarms46
Troubleshooting47
Technical Data49
General49
General Settings49
Settings Chlorine Control49
Settings Ph Control50
Factory Settings (Default Values)51
Redox Measuring and Control Part51
Ph Measuring and Control Part51
Service / Basic Settings52
Function: Delete Data Memory (Reset Factory Settings)52
Parameter Table for Service Staff52
Maintenance and Servicing - Summary54
Appendix56
Liquid Dosing Agents for Your CF Control 100 System56
Accessories and Spare Parts57
Electrical Connection Diagram58

ChemoformGroup CF Control 100 - The Measuring Cell

Table of Contents