CF Control 100 General information
Table of contents
1 General Information 6
1.1 General information 6
1.2 Notes in bold 6
1.3 Warranty 6
1.4 Safety Instructions 7
1.5 Transport damage 7
1.6 Information about carbonate hardness (CH) 8
2 Description 9
2.1.1 Equipment / Features 9
3 Installation 10
3.1 Checking the delivery 10
3.2 Assembly of the system 10
3.3 Installation drawing "Closed sample water system" 11
3.4 Installation drawing wall mounting plate with compact measuring cell 13
3.5 Connecting the measuring cell 14
3.6 The measuring cell 16
3.7 Electrodes 17
3.8 Connection of dosing pumps 17
3.9 Dosing points R 1/4“ 17
3.10 pH reduce / pH raise 18
3.11 Container empty message 18
3.12 Sample water deficiency sensor 18
3.13 Heating / Solar heating 18
4 Electrical connection 20
4.1 Opening the unit 20
4.2 Terminals 21
4.3 Connections of filter pump 23
4.4 Connection heating / solar heating 23
5 Device description 24
6 Operation and functions 25
6.1 Changing the setting parameters (example) 25
6.2 Table of setting parameters 26
6.3 Explanations of setting parameters 28
6.3.1 Code [Parameter 0] 28
6.3.2 Set points [parameters 1, 4, 9] 29
6.3.3 Time [parameter 4] 29
6.3.4 Switching marks [parameters 21 - 37] 29
6.3.5 Release dosing [parameters 80, 81] 29
6.3.6 Release heating [parameter 82] 29
6.3.7 Slope of probe [parameter 86] 29
6.3.8 Zero point probe [parameter 87] 29
6.3.9 P-band [parameters 2, 5] 30
6.3.10 Switch-on delay [parameter 10] 30
6.3.11 Maximum dosing time (dosing time monitor) [parameters 11, 12] 30
6.3.12 Maximum daily dosing quantity [parameters 15, 16] 31
To Next Page
Loading...