Operating instructions
CF Control 100
6.3.13 Dosing capacity of pumps [parameters 88, 89] 31
6.3.14 Code for calibration [parameter 92] 31
7 Calibrating pH electrode and chlorine value 32
7.1 Calibrating the pH electrode 32
7.2 Querying the slope / zero point of the pH electrode [parameters 86, 87] 33
7.3 Setting the disinfectant content 33
8 Setting the heating and the solar heating 34
8.1 Reading the water temperature [parameter 7] 34
8.2 Setting the temperature set point [parameter 9] 34
8.3 Activation of the heating 35
8.4 Changing from heating control to solar heating control (parameter 94) 35
8.5 Reading the temperature of the solar sensor [parameter 8] 35
8.6 Activation of the solar heating [parameter 94] 36
9 Control of the filter pump 38
9.1 Setting the time [parameter 40] 38
9.2 Setting the filter times switching marks [parameters 20 - 37] 38
9.3 24h operation 40
10 Commissioning 41
10.1 What to do before commissioning the system 41
10.2 Commissioning 42
10.3 Activating the complete system 42
10.3.1 Control limits 42
10.4 dinoAccess remote visualization / remote control (option) 43
10.4.1 Reset of WiFi settings 43
10.4.3 Troubleshooting 43
11 Maintenance and servicing 44
11.1 Cleaning and calibrating the electrodes 44
11.2 Cleaning the measuring cell 45
11.3 Wintering 45
12 Alarm messages 46
12.1 List of error messages: 46
12.2 Resetting of alarms 46
13 Troubleshooting 47
14 Technical data 49
14.1 General 49
14.1.1 General settings 49
14.1.2 Settings chlorine control 49
14.1.3 Settings pH control 50
14.2 Factory settings (default values) 51
14.2.1 Redox measuring and control part 51
14.2.2 pH measuring and control part 51
15 Service / Basic settings 52
To Next Page
Loading...