CF Control 100 General information
1.4 Safety Instructions
The equipment is manufactured and tested in accordance with DIN EN 61010-1 / VDE 0411 - 1
(Safety requirements for electrical equipment for measurement, control and laboratory use - Part 1:
General requirements), and left the factory in a safe condition. In order to maintain this condition and
to ensure a continued safe operation, the user must observe the notes and warnings contained in this
technical manual. If it must be assumed that a safe operation is no longer possible, the device must be
turned off and taken out of service, and made safe against accidental operation.
This is the case:
- if the system shows visible evidence of damage,
- if the system is apparently no longer in working order,
- after longer periods of storage under unfavourable conditions.
1.5 Transport damage
The CF Control 100 is carefully packed by us for the purpose of transport. Please check that the
delivery is complete and undamaged. Any transport damage must be notified immediately (carrier).
The system must never be exposed to temperatures outside the range of -20 to +65°C (transport and
interim storage).
Subject to technical changes and changes in the composition of components.
To Next Page
Loading...