Chison ECO 2 - Page 59

ECO 2 Ultrasound Diagnostic System
Page 50 / 189
5.7.8.1 Post Processing
 Chroma
Adjust the type of the chroma.
Choose [Chroma], and rotate [MENU] button to select the Chroma type.
 2D Map
Select the type of the scale curve.
Choose [2D Map], and rotate [MENU] button to select the scale curve type.
 B Gamma
Adjust image gray value parameters.
Choose [B Gamma], and rotate [MENU] button to select the B Gamma parameters.
 B Rejection
Adjust image gray scale inhibition parameters
Choose [B Rejection], and rotate [MENU] button to adjust B Rejection parameters.
5.7.9 Advance
In B Mode, select Advance, after pressing [MENU] button, it will appear Advance options.
5.7.9.1 Zoom Coef
Adjust the size of the ruler and image.
Choose [Zoom Coef], and rotate [MENU] button to adjust, the range is 60%~100%.
5.7.9.2 MB
Through opening MB to improve image quality.
Press [MENU] to turn on or turn off the MB function.
5.7.9.3 Trapezoidal Mode
Press [MENU] to turn on or turn off the trapezoidal function. This function is activated by linear
probes.
5.7.9.4 Biopsy
Show or hide biopsy.
Press the [MENU] to show or hide biopsy line.
After the biopsy line shows, press the [ENTER] button to activate the adjustment function of biopsy
line, horizontal rolling the trackball can translate the biopsy line, vertical rolling the trackball can
adjust the line angle, press the [UPDATE] button to set the default biopsy line position.
Accessories