Control Installation Chore-Tronics® 3 Control
100
MT2398C
Digital Inputs Wiring
Digital inputs consist of Water Meters, Feed Scales, Air Speed Sensor, Low Water Pressure Switch, Max
Feed Run Time Alarm Input, and PDS Flush Feedback. These Inputs can be wired to any of the digital
inputs (DI 1 thru DI 8) on the IO board (Figure 27 below). Complete the analog input Assignment
diagram on page 137 to indicate where each digital input is connected to the IO board and also record it
on the Input Assignment Decal (Item 1, Figure 27) that is placed on the Cover Plate inside the Chore-
Tronics
®
3 Main Box. Also refer to the following sections for information specific to each type of digital
input.
To Water Meter
To Feed Scale
Figure 27. Digital Input Wiring
1
Item Description
1 Input Assignment Decal
To Next Page
Loading...