1. Select the Environment button.
History Number of days.
Mode Temperature 100 days
Sensors (all assigned) 14 days
Humidity House 14 days
Heat Run Times 14 days
2. Select one of the tab buttons along the bottom to
view that Tab’s History.
Note: Tabs that are grayed out have no history
because no sensor has been installed.
3. Press the Mode Temperature Tab
4. Use the slide bar on the right to move history up
and down.
5. Press the Sensors Tab
Some of the history selections have more than
one sensor. To select a Sensor, use the drop
down as shown to the right.
Environment
Code Number of days.
Water 14 days
Feed 14 days
Mortality 100 days
Auxiliary 14 days
Feed Lines 14 days
4
5
To Next Page
Loading...
Need help?
General